I enjoy seeing real film every now and then.
Wow, this is an incredible guide thanks for showing me
I figured there might be something like this that i hadn’t seen. I’ll look into it tomorrow, i get the feeling this would cause the inconsistency.
I have never bought an ender. I just happen to have one :P
Ah, thank you for the advice and the link!
The falling prints i think have issues in the same spots, there are relatively small patches around the print surface that don’t print very well, though they don’t seem to correspond to the bed leveling screws or anything. Now that i say that I’ll have to check that I’m using the mesh level correctly when i get home.
I’m still using a Bowden type extruder. The extruder itself is a generic aluminum one. My filament is run out of a sunlu dryer by the side of the machine.
I think i actually raised the jerk at one point to reduce the radius on corners, so i can bring that back down again and experiment with acceleration.
I have a glass bed and I’m using the tramming function with the mriscoc firmware to give me depth readings for each of the four screws, and I usually reign them in to about 0.04mm range. Parts close to each other tend to have similar but not the same results, and i think the patches are too small to be from bed leveling, usually only a couple centimeters.
I can redo esteps, i can see what you mean about the overextrusion. I only set my esteps to the number recommended by the manufacturer of my extruder, but i haven’t measured it myself yet, maybe that’s a bit silly of me. Though if that’s the problem then I’m still curious why it’s different in different areas.
I can check out acceleration too, i looked up what acceleration and jerk meant at one point but it didn’t make much sense to me at the time.
Common piracy W
Why does Lemmy not have a “block this particular post” option?
The colors in this photo are beautiful. You can really see the contrast pop between each element of the composition.
Imagine being a little water droplet, floating through the sky, accumulating other water droplets to your cause, eventually growing heavy enough that you can leave the rain clouds blowing you around and you fall hundreds of feet only to land directly in some dude’s anus.
I hope the crumbling job market for programmers will make those people look elsewhere.
If only i knew the truths 😞
I’m glad. What’s the point of working if you’re losing money by doing it?
If it’s infinite without repeating patterns then it just contain all patterns, no? Eh i guess that’s not how that works, is it? Half of all patterns is still infinity.
They rounded it on the wrong axis
Who works for who depends on how organized each one is.
I may have found a phone for you. It’s called the unihertz tank 2
https://www.unihertz.com/products/tank-2
Comes with a few other really interesting features you don’t see on any other phone (like a goddamn laser projector?), though i think the processor is a little underpowered.
If i was a hiring manager I’d take that answer.