Hanging out in bed browsing Thangs on mobile.

I can get STLs, my slicer settings are pretty set and forget, I should be able to just upload an STL or a few, say “fill the plate” and go, without pulling out mg laptop.

It might be pretty lazy, but it isn’t crazy.

Acetone is fine.

This is actually one of my pet peeves. Acetone is far from the “universal plastic solvent” that it has as a reputation…

Ultem, aka pei actually does great with acetone: https://www.astisensor.com/ultem.pdf.

I use acetone pretty regularly on my sheets and I haven’t noticed any bad effects. Usually it is best to use soap and water, acetone and isopropyl alcohol. If things won’t stick, do all three (in that order).